LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Highlander XLE, AWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Starting System [2GR-FKS] (W/ Stop And Start) - Service Information - (Except Hybrid) >> STARTER (w/ Stop And Start System) >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [11/2016 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [11/2016 - ]

  3. REMOVE RADIATOR SIDE DEFLECTOR SEAL LH 

    Refer to PROCEDURE - Step 1

  4. REMOVE RADIATOR SIDE SEAL RH 

    Refer to PROCEDURE - Step 2

  5. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 3

  6. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  7. REMOVE BATTERY 

    Refer to PROCEDURE - Step 26

  8. REMOVE INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 27

  9. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 28

  10. REMOVE STARTER ASSEMBLY 
    1. Disconnect the starter assembly connector.
      GTY731997Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Open the terminal cap.
    3. Remove the nut and disconnect terminal 30.
    4. Type A:
      GTY692831Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 2 bolts and starter assembly.
    5. Type B:
      GTY691485Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 2 nuts and the starter assembly.
      2. Using an E8 "TORX" socket wrench, remove the 2 stud bolts from the automatic transaxle assembly.
scientia non olet · About LEMON Manuals