On-Vehicle Inspection [12/2013 - ]: Procedure
- INSPECT BACK UP LP RELAY
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher 3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the BACK UP LP relay.
- Measure the resistance according to the value(s) in the table below.