LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Highlander LE Plus, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 114 (SFI System (2GR-FXS) - Diagnostic Codes - (Hybrid) (2 Of 4)) >> SFI System >> DTC P107B: Fuel Rail Pressure Sensor "B" Circuit Range/Performance [11/2016 - 10/2017] >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different variant/trim than selected.
ALL

Monitor runs whenever the following DTCs are not stored None
STUCK MONITOR

All of the following conditions are met for 2 seconds or more -
Engine coolant temperature sensor malfunction Not detected
Intake air temperature sensor (mass air flow meter sub-assembly) malfunction Not detected
Fuel pressure sensor (for low pressure side) circuit malfunction Not detected
Auxiliary battery voltage 11 V or higher
Fuel cut Off
CORRELATION MONITOR

All of the following conditions are met -
Engine coolant temperature sensor malfunction Not detected
Intake air temperature sensor (mass air flow meter sub-assembly) malfunction Not detected
Fuel pressure sensor (for low pressure side) circuit malfunction Not detected
Auxiliary battery voltage 11 V or higher
Engine coolant temperature -10 to 100°C (14 to 212°F)
Intake air temperature (for mass air flow meter sub-assembly) -10 to 50°C (14 to 122°F)
Atmospheric pressure 76 kPa (abs) [11 psi (abs)] or higher
After first engine start -
Fuel pump (for low pressure side) operation at maximum duty 1 second or more