Confirmation Driving Pattern
WARNING: This page is about a different variant/trim than selected.
- Turn the power switch off and leave the vehicle for several hours.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG) and turn the Techstream on [A].
- Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp and Intake Air.
- Check that the value of the Data List item "Coolant Temp" is 56°C (133°F) or less and the value of the Data List item "Intake Air" is between 0 and 35°C (32 and 95°F).
- Put the engine in INSPECTION MODE (maintenance mode).
- Set the heater to MAX HOT with fresh air mode selected and turn the A/C off.
- Start the engine.
- With the engine running, drive the vehicle at 80 km/h (50 mph) for 15 minutes [B].WARNING:
When performing the confirmation driving pattern, obey all speed limits and traffic laws.
HINT:
If the engine stops, further depress the accelerator pedal to restart the engine.
- After the value of the Data List item Coolant Temp stabilizes, check that it is 75°C (167°F) or higher [C].
HINT:
If the value of the Data List item Coolant Temp is less than 75°C (167°F) while driving the vehicle at 80 km/h (50 mph), inspect the cooling system and thermostat.