LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Highlander LE Plus, AWD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belts (Service Information) (Except Hybrid) >> FRONT SEAT INNER BELT ASSEMBLY (for Power Seat) >> Installation [12/2013 - ] >> Procedure

Installation [12/2013 - ]: Procedure

  1. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side) 
    1. Install the front seat belt anchor plate as shown in the illustration.
      GTY427286Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the front seat inner belt assembly LH with the nut.
      GTY455061Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protruding Part

      Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

      NOTE:

      Do not allow the anchor part of the front seat inner belt assembly LH to overlap the protruding part of the front seat adjuster.

    3. Engage the clamp.
    4. Connect the connector.
    5. Engage each clamp under the front seat assembly.
  2. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side) 
    1. Install the front seat belt anchor plate as shown in the illustration.
      GTY423861Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the front seat inner belt assembly RH with the nut.
      GTY443391Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protruding Part

      Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf) 

      NOTE:

      Do not allow the anchor part of the front seat inner belt assembly RH to overlap the protruding part of the front seat adjuster.

    3. Connect the connector.
    4. Engage each clamp under the front seat assembly.
  3. INSTALL FRONT SEAT ASSEMBLY 

    Refer to INSTALLATION [12/2013 - ]

scientia non olet · About LEMON Manuals