Inspection [12/2013 - ]: Procedure

INSPECT DOOR CONTROL SWITCH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Component without harness connected (Door Control Switch)

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Condition	Specified Condition
1 (MSE) - 2 (MSW)	Switch off	10 kΩ or higher
1 (MSE) - 2 (MSW)	Switch on	Below 1 Ω

If the result is not as specified, replace the door control switch.