LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Highlander LE Plus, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Service Information) (Except Hybrid) >> Power Back Door Closer Switch >> Inspection [12/2013 - ] >> Procedure

Inspection [12/2013 - ]: Procedure

  1. INSPECT BACK DOOR CONTROL SWITCH 
    1. Check the operation of the back door control switch.
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        4 (CLS) - 1 (E) Back door control switch not pushed 10 kΩ or higher
        Back door control switch pushed Below 1 Ω

        If the result is not as specified, replace the back door control switch.

        GTY453802Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Back Door Control Switch)
    2. Check that the switch illuminates.
      GTY439439Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Back Door Control Switch)
      1. Apply battery voltage to the power back door control switch and check that the LED illuminates.

        OK

        Measurement Condition Specified Condition
        Battery positive (+) → 3 (ILL+)
        Battery negative (-) → 2 (ILL-)        		 LED illuminates

        If the result is not as specified, replace the back door control switch.

scientia non olet · About LEMON Manuals