Adjustment [11/2016 - ]: Procedure

See step  1

1. Horizontally and vertically adjust the hood.
   1. Loosen the hinge bolts of the hood.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   2. Adjust the clearance between the hood and front fender by moving the hood.
   3. Tighten the hinge bolts after adjustment.

      Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf) 

2. Adjust the height of the front end of the hood using the hood bumper cushions.
   1. Adjust the hood bumper cushions so that the heights of the hood and fender are aligned.

      HINT: 

      Raise or lower the front end of the hood by turning the hood bumper cushions.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Remove radiator grille.

   Refer to REMOVAL [11/2016 - ]

4. Adjust the hood lock.
   1. Using a screwdriver, remove the hood lock nut cap.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *a	Protective Tape

      HINT: 

      Tape the screwdriver tip before use.

   2. Loosen the 2 bolts and hood lock bolt.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *1	Hood Lock Bolt

   3. Adjust the hood lock and tighten the 2 bolts and hood lock bolt.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   4. Check that the striker can engage with the hood lock smoothly.
   5. Install a new hood lock nut cap.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

5. Install radiator grille.

   Refer to INSTALLATION [11/2016 - ]