Inspection [12/2013 - 11/2016]: Procedure
- INSPECT STOP LIGHT SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Stop Light Switch Assembly)*b Not Pushed *c Pushed *d Switch Pin Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 Switch pin pushed 10 kΩ or higher Switch pin not pushed Below 1 Ω 3 - 4 Switch pin pushed Below 200 Ω Switch pin not pushed 10 kΩ or higher If the result is not as specified, replace the stop light switch assembly.
- Measure the resistance according to the value(s) in the table below.