Inspection [11/2016 - ]: Procedure
- INSPECT REAR COMBINATION LIGHT ASSEMBLY LH
*a Component without harness connected
(Rear Combination Light Assembly LH)- Apply battery voltage to the rear combination light assembly LH and check that the lights illuminate.
OK
Condition Specified Condition Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 5Stop light illuminates Battery positive (+) → Terminal 4
Battery negative (-) → Terminal 5Taillight and rear side marker light illuminates If the result is not as specified, replace the rear combination light assembly LH.
- Apply battery voltage to the rear combination light assembly LH and check that the lights illuminate.
- INSPECT REAR COMBINATION LIGHT ASSEMBLY RH
*a Component without harness connected
(Rear Combination Light Assembly RH)- Apply battery voltage to the rear combination light assembly RH and check that the lights illuminate.
OK
Condition Specified Condition Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 5Stop light illuminates Battery positive (+) → Terminal 4
Battery negative (-) → Terminal 5Taillight and rear side marker light illuminates If the result is not as specified, replace the rear combination light assembly RH.
- Apply battery voltage to the rear combination light assembly RH and check that the lights illuminate.