Inspection [12/2013 - ]: Procedure
- INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*A w/ Front Fog Light *a Component without harness connected
(Headlight Dimmer Switch Assembly)Standard Resistance
LIGHT CONTROL SWITCHTester Connection Condition Specified Condition 18 (T) - 15 (EL) Light control switch off*2 or DRL OFF*3 10 kΩ or higher 19 (H) - 15 (EL) 10 kΩ or higher 20 (A) - 15 (EL) 10 kΩ or higher 19 (H) - 18 (T) 10 kΩ or higher 20 (A) - 18 (T) 10 kΩ or higher 19 (H) - 20 (A) 10 kΩ or higher 18 (T) - 15 (EL) Light control switch in tail position Below 1 Ω 18 (T) - 15 (EL) Light control switch in head position Below 1 Ω 19 (H) - 15 (EL) Below 1 Ω 18 (T) - 19 (H) Below 1 Ω 20 (A) - 15 (EL) Light control switch in AUTO position Below 1 Ω DIMMER SWITCHTester Connection Condition Specified Condition 16 (HL) - 15 (EL) Dimmer switch in low position Below 1 Ω 14 (HU) - 15 (EL) Dimmer switch in high position Below 1 Ω 14 (HU) - 15 (EL) Dimmer switch in high flash position Below 1 Ω 17 (HF) - 15 (EL) Below 1 Ω 14 (HU) - 17 (HF) Below 1 Ω TURN SIGNAL SWITCHTester Connection Condition Specified Condition 12 (TR) - 15 (EL) Turn signal switch in neutral position 10 kΩ or higher 11 (TL) - 15 (EL) 10 kΩ or higher 13 (CR) - 15 (EL) 10 kΩ or higher 12 (TR) - 11 (TL) 10 kΩ or higher 13 (CR) - 11 (TL) 10 kΩ or higher 12 (TR) - 13 (CR) 10 kΩ or higher 12 (TR) - 15 (EL) Turn signal switch in right turn position Below 1 Ω 12 (TR) - 15 (EL) Turn signal switch in full right turn position Below 1 Ω 13 (CR) - 15 (EL) Below 1 Ω 12 (TR) - 13 (CR) Below 1 Ω 11 (TL) - 15 (EL) Turn signal switch in left turn position Below 1 Ω 11 (TL) - 15 (EL) Turn signal switch in full left turn position Below 1 Ω 13 (CR) - 15 (EL) Below 1 Ω 11 (TL) - 13 (CR) Below 1 Ω FOG LIGHT SWITCH*1Tester Connection Condition Specified Condition 9 (BFG) - 8 (LFG) Fog light switch off 10 kΩ or higher 9 (BFG) - 8 (LFG) Fog light switch in front position Below 1 Ω - *1: w/ Front Fog Light
- *2: w/o DRL OFF Switch
- *3: w/ DRL OFF Switch
If the result is not as specified, replace the headlight dimmer switch assembly.
- Measure the resistance according to the value(s) in the table below.