How To Proceed With Troubleshooting [08/2016 - ]: Procedure

Result

NEXT 

See step  2

Result

NEXT 

See step  3

1. Measure the battery voltage.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

NEXT 

See step  4

1. Check if CAN communication DTCs are output.

   Refer to DIAGNOSIS SYSTEM [08/2016 - ]

   Result

   Result	Proceed to
   CAN communication DTCs are not output.	A
   CAN communication DTCs are output.	B

Result: 

B 

REFER TO CAN COMMUNICATION SYSTEM.  HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - ] 

Result: 

A 

See step  5

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [08/2016 - ] 

   Body Electrical > Combination Meter > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output.	A
   DTCs are output.	B

Result: 

B 

REFER TO DIAGNOSTIC TROUBLE CODE CHART.  DIAGNOSTIC TROUBLE CODE CHART [08/2016 - ]  

Result: 

A 

See step  6

Result

NEXT 

See step  7

Result

NEXT 

See step  8

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [08/2016 - ] 

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table.	A
   Fault is listed in Problem Symptoms Table.	B

Result: 

B 

REFER TO PROBLEM SYMPTOMS TABLE.  PROBLEM SYMPTOMS TABLE [08/2016 - ]  

Result: 

A 

See step  9

Result

NEXT 

See step  10

Result

NEXT 

See step  11

Result

NEXT 

END