LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Corolla L >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Diagnostics - Introduction (1 Of 2) (Model Code: ZRE172) >> Meter / Gauge System >> Initialization [08/2016 - ] >> Initialization [08/2016 - ]

Initialization [08/2016 - ]

  1. MAINTENANCE REQUIRED REMINDER RESET PROCEDURE (for Multi-information Display (Segment LCD Type)) 

    HINT: 

    The DISP switch is located on the steering pad switch assembly.

    1. Turn the ignition switch to ON.
    2. Press the DISP switch until the TRIP A appears.
    3. Turn the ignition switch off.
    4. Turn the ignition switch to ON while pressing and holding the DISP switch. Hold the DISP switch until the following conditions are met and 5 seconds have elapsed.
      1. The TRIP A shows "000000".
      2. The multi-information display shows that the reset is complete.
  2. MAINTENANCE REQUIRED REMINDER RESET PROCEDURE (for Multi-information Display (Dot LCD Type)) 

    HINT: 

    The ODO/TRIP switch knob is located on the combination meter assembly.

    1. Turn the ignition switch to ON.
    2. Press the ODO/TRIP switch knob until the TRIP A appears.
    3. Turn the ignition switch off.
    4. Turn the ignition switch to ON while pressing and holding the ODO/TRIP switch knob. Hold the ODO/TRIP switch knob until the following conditions are met and 5 seconds have elapsed.
      1. The TRIP A shows "000000".
      2. The multi-information display shows that the reset is complete.
  3. MAINTENANCE REQUIRED REMINDER RESET PROCEDURE (for Multi-information Display (Color Type)) 

    HINT: 

    Initialization is performed using the multi-information display.

    1. Turn the ignition switch to ON.
    2. Enter the following menus: Settings / Scheduled Maintenance.
    3. Perform initialization according to the multi-information display.
scientia non olet · About LEMON Manuals