LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt - Service Information (Except Hybrid) >> Rear Seat Outer Belt Assembly With Pre-TENSIONER >> Removal [06/2017 - 09/2019] >> Procedure

Removal [06/2017 - 09/2019]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [06/2017 - 09/2019]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    For A25A-FKS:

    Refer to PROCEDURE - Step 2 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 2 [08/2018 - 10/2020]

    For 2GR-FKS:

    Refer to PROCEDURE - Step 2

    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    • If an airbag deploys for any reason, it may cause a serious injury.
    GTY684647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type) 

    Refer to REMOVAL [06/2017 - 10/2020]

  4. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Fold Down Seat Type) 

    For TMC Made:

    Refer to PROCEDURE - Step 3

  5. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) 

    For TMC Made:

    Refer to PROCEDURE - Step 4

    For TMMK Made:

    Refer to PROCEDURE - Step 7

  6. REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 8

  7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 11

  8. REMOVE REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 12

  9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Fold Down Seat Type) 

    HINT: 

    Use the same procedure as for the LH side.

  10. REMOVE REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type) 

    HINT: 

    Use the same procedure as for the LH side.

  11. REMOVE INNER ROOF SIDE GARNISH LH 

    Refer to PROCEDURE - Step 17 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 17 [08/2018 - 09/2019]

  12. REMOVE INNER ROOF SIDE GARNISH RH 

    HINT: 

    Use the same procedure as for the LH side.

  13. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH 
    1. Remove the bolt to disconnect the floor anchor of the rear seat outer belt assembly LH.
      GTY771365Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  14. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  15. REMOVE CENTER STOP LIGHT SET 

    Refer to REMOVAL [03/2017 - ]

  16. REMOVE REAR SEAT SHOULDER BELT HOLE COVER 
    1. Disengage the 2 claws and 2 guides to remove the rear seat shoulder belt hole cover.

      HINT: 

      Use the same procedure for the other rear seat shoulder belt hole covers.

      GTY771370Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  17. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY 
    1. Fold the rear seatback assembly LH and rear seatback assembly RH forward.
    2. Remove the 2 clips.
      GTY753475Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the 3 clips and 5 guides.
      GTY757673Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.
  18. REMOVE REAR SEAT OUTER BELT ASSEMBLY LH 
    1. Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.

      HINT: 

      Tape the screwdriver tip before use.

      GTY743079Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Locking Button
      *c Release
    2. Remove the 2 bolts.
      GTY759791Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the guide to remove the rear seat outer belt assembly LH.
  19. REMOVE REAR SEAT OUTER BELT ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  20. REMOVE REAR SEAT BELT RETRACTOR COVER 
    1. Remove the rear seat belt retractor cover as shown in the illustration.

      HINT: 

      Use the same procedure for the RH side and LH side.

      GTY769595Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
scientia non olet · About LEMON Manuals