LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt - Service Information (Except Hybrid) >> Rear Center Seat Outer Belt Assembly >> Removal [09/2019 - 10/2020] >> Procedure

Removal [09/2019 - 10/2020]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [09/2019 - 03/2020] , or refer to PRECAUTION [03/2020 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    For A25A-FKS:

    Refer to PROCEDURE - Step 2

    For 2GR-FKS:

    Refer to PROCEDURE - Step 2

    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    • If an airbag deploys for any reason, it may cause a serious injury.
    GTY684647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type) 

    Refer to REMOVAL [06/2017 - 10/2020]

  4. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 5

  5. REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 6

  6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 9

  7. REMOVE REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 10

  8. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Fold Down Seat Type) 

    HINT: 

    Use the same procedure as for the LH side.

  9. REMOVE REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type) 

    HINT: 

    Use the same procedure as for the LH side.

  10. REMOVE INNER ROOF SIDE GARNISH LH 

    Refer to PROCEDURE - Step 15 [09/2019 - 03/2020] , or refer to PROCEDURE - Step 15 [03/2020 - 10/2020]

  11. REMOVE INNER ROOF SIDE GARNISH RH 

    HINT: 

    Use the same procedure as for the LH side.

  12. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH 

    See step  12

  13. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  14. REMOVE CENTER STOP LIGHT SET 

    Refer to REMOVAL [03/2017 - ]

  15. REMOVE REAR SEAT SHOULDER BELT HOLE COVER 

    See step  15

  16. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY 

    See step  16

  17. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY 
    1. Remove the 2 bolts.
      GTY772769Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guide to remove the rear center seat outer belt assembly.

      HINT: 

      As the rear center seat outer belt assembly cannot be separated from the rear seat inner belt assembly RH, when replacing the rear center seat outer belt assembly with a new one, the rear seat inner belt assembly RH will also be replaced.

      See step  8

  18. REMOVE SEAT BELT RETRACTOR COVER 
    1. Remove the seat belt retractor cover as shown in the illustration.
      GTY751195Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction