Removal [03/2017 - 06/2017]: Procedure
- PRECAUTION WARNING:
Be sure to read Precaution thoroughly before servicing.
Refer to PRECAUTION [03/2017 - 06/2017]
NOTE:After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [03/2017 - 06/2017]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL WARNING:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- If an airbag deploys for any reason, it may cause a serious injury.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [03/2017 - 06/2017]
- DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
Refer to PROCEDURE - Step 3
- REMOVE REAR SEAT CUSHION ASSEMBLY
Refer to PROCEDURE - Step 4
- REMOVE REAR SEAT CUSHION LOCK HOOK
Refer to PROCEDURE - Step 5
- DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
Refer to PROCEDURE - Step 8
- REMOVE REAR SIDE SEATBACK ASSEMBLY LH
Refer to PROCEDURE - Step 9
- DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
HINT:
Use the same procedure as for the LH side.
- REMOVE REAR SIDE SEATBACK ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
- REMOVE INNER ROOF SIDE GARNISH LH
Refer to PROCEDURE - Step 14
- REMOVE INNER ROOF SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
- DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH
See step 12
- DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
- REMOVE CENTER STOP LIGHT SET
Refer to REMOVAL [03/2017 - ]
- REMOVE REAR SEAT SHOULDER BELT HOLE COVER
See step 15
- REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
See step 16
- REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY
- REMOVE SEAT BELT RETRACTOR COVER