Removal [09/2019 - 10/2020]: Procedure
- PRECAUTION NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [09/2019 - 03/2020] , or refer to PRECAUTION [03/2020 - ]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
For A25A-FKS:
Refer to PROCEDURE - Step 2
For 2GR-FKS:
Refer to PROCEDURE - Step 2
- REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)
Refer to REMOVAL [06/2017 - 10/2020]
- REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)
Refer to PROCEDURE - Step 5
- REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)
Refer to PROCEDURE - Step 6
- DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Fold Down Seat Type)
Refer to PROCEDURE - Step 9
- REMOVE REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type)
Refer to PROCEDURE - Step 10
- DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Fold Down Seat Type)
HINT:
Use the same procedure as for the LH side.
- REMOVE REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type)
HINT:
Use the same procedure as for the LH side.
- REMOVE INNER ROOF SIDE GARNISH LH
Refer to PROCEDURE - Step 15 [09/2019 - 03/2020] , or refer to PROCEDURE - Step 15 [03/2020 - 10/2020]
- REMOVE INNER ROOF SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
- DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH
See step 12
- DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
- REMOVE CENTER STOP LIGHT SET
Refer to REMOVAL [03/2017 - ]
- REMOVE REAR SEAT SHOULDER BELT HOLE COVER
See step 15
- REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
See step 16
- REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET
HINT:
Use the same procedure for all child restraint seat tether anchor brackets.