LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt - Service Information (Except Hybrid) >> Child Restraint Seat Tether Anchor >> Removal [06/2017 - 09/2019] >> Procedure

Removal [06/2017 - 09/2019]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [06/2017 - 09/2019]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    For A25A-FKS:

    Refer to PROCEDURE - Step 2 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 2 [08/2018 - 10/2020]

    For 2GR-FKS:

    Refer to PROCEDURE - Step 2

    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    • If an airbag deploys for any reason, it may cause a serious injury.
    GTY684647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type) 

    Refer to REMOVAL [06/2017 - 10/2020]

  4. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Fold Down Seat Type) 

    For TMC Made:

    Refer to PROCEDURE - Step 3

  5. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) 

    For TMC Made:

    Refer to PROCEDURE - Step 4

    For TMMK Made:

    Refer to PROCEDURE - Step 7

  6. REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 8

  7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 11

  8. REMOVE REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 12

  9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Fold Down Seat Type) 

    HINT: 

    Use the same procedure as for the LH side.

  10. REMOVE REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type) 

    HINT: 

    Use the same procedure as for the LH side.

  11. REMOVE INNER ROOF SIDE GARNISH LH 

    Refer to PROCEDURE - Step 17 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 17 [08/2018 - 09/2019]

  12. REMOVE INNER ROOF SIDE GARNISH RH 

    HINT: 

    Use the same procedure as for the LH side.

  13. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH 

    See step  13

  14. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  15. REMOVE CENTER STOP LIGHT SET 

    Refer to REMOVAL [03/2017 - ]

  16. REMOVE REAR SEAT SHOULDER BELT HOLE COVER 

    See step  16

  17. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY 

    See step  17

  18. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET 

    HINT: 

    Use the same procedure for all child restraint seat tether anchor brackets.

    1. Remove the bolt.
      GTY771342Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guide to remove the child restraint seat tether anchor bracket.
scientia non olet · About LEMON Manuals