LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt - Service Information (Except Hybrid) >> Child Restraint Seat Anchor Bracket >> Installation [06/2017 - 09/2019] >> Procedure

Installation [06/2017 - 09/2019]: Procedure

  1. INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH 
    1. Temporarily install the child restraint seat anchor bracket sub-assembly LH with the 2 bolts.
      GTY742815Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Fully tighten the bolt (A), and then the bolt (B) to install the child restraint seat anchor bracket sub-assembly LH.

      Torque: 19.5 N*m (199 kgf*cm, 14 ft.*lbf) 

    3. Engage each clamp.
  2. INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  3. INSTALL REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 7

  4. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) 

    For TMC Made:

    Refer to PROCEDURE - Step 11

    For TMMK Made:

    Refer to PROCEDURE - Step 8

  5. CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Fold Down Seat Type) 

    For TMC Made:

    Refer to PROCEDURE - Step 12

  6. INSTALL REAR SEAT CUSHION LOCK HOOK (for Fixed Seat Type) 

    Refer to PROCEDURE - Step 2

  7. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type) 

    Refer to PROCEDURE - Step 3

scientia non olet · About LEMON Manuals