LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System - Service Information (2 Of 2) (Except Hybrid) >> Rear Airbag Sensor >> Removal [06/2017 - 09/2019] >> Procedure

Removal [06/2017 - 09/2019]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing.

    Refer to PRECAUTION [06/2017 - 09/2019]

    GTY607029Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [06/2017 - 09/2019]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    for A25A-FKS: Refer to PROCEDURE - Step 2 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 2 [08/2018 - 10/2020]

    for 2GR-FKS: Refer to PROCEDURE - Step 2

    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    GTY684647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [06/2017 - 08/2018] , or refer to INITIALIZATION [08/2018 - 09/2019]

  3. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Fold Down Seat Type) 

    for TMC Made: Refer to PROCEDURE - Step 3

  4. REMOVE REAR SEAT CUSHION ASSEMBLY 

    for TMC Made Fold Down Seat Type: Refer to PROCEDURE - Step 4

    for TMMK Made Fold Down Seat Type: Refer to PROCEDURE - Step 7

    for TMMK Made Fixed Seat Type: Refer to PROCEDURE - Step 3

  5. REMOVE REAR SEAT CUSHION LOCK HOOK 

    for Fold Down Seat Type: Refer to PROCEDURE - Step 8

    for Fixed Seat Type: Refer to PROCEDURE - Step 4

  6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP (for Fold Down Seat Type) 

    HINT: 

    Disconnect the rear door opening trim weatherstrip to the extent that allows the removal of the rear side seatback assembly.

  7. REMOVE REAR SIDE SEATBACK ASSEMBLY (for Fold Down Seat Type) 

    Refer to PROCEDURE - Step 12

  8. REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type) 

    Refer to PROCEDURE - Step 5

  9. REMOVE SIDE NO. 2 AIRBAG SENSOR 
    1. Check that the ignition switch is off.
    2. Check that the cable is disconnected from the negative (-) battery terminal.
      WARNING:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      GTY684647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the connector from the side No. 2 airbag sensor.
      NOTE:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

      1. Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)
        GTY751785Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a White Housing Lock *b Yellow CPA
        Push in this Direction Slide in this Direction
      2. Push down the white housing lock again and disconnect the connector.
        NOTE:

        Do not push down the part (A) shown in the illustration when disconnecting the connector.

    4. Remove the bolt and disengage the claw to remove the side No. 2 airbag sensor.
      GTY770208Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Check that the position of the white housing lock is as shown in the illustration.
      GTY446410Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Correct *b Incorrect
scientia non olet · About LEMON Manuals