Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ECM removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Battery terminal is disconnected/reconnected | Perform steering sensor zero point calibration | Lane departure alert system (w/ Steering Control) | Refer to INITIALIZATION [03/2017 - 10/2020] |
| Pre-collision system | |||
| Intelligent clearance sonar system*1 | |||
| Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [03/2017 - ] | |
| Panoramic view monitor system | Refer to INITIALIZATION [06/2017 - 10/2020] | ||
| Replacement of ECM | Vehicle Identification Number (VIN) registration | MIL comes on | Refer to REGISTRATION [06/2017 - ] |
| ECU communication ID registration (Immobiliser system) | Engine start function | Refer to REGISTRATION [03/2017 - 09/2019] , or refer to REGISTRATION [09/2019 - 08/2022] | |
| Replacement of ECM (If possible, read the transaxle compensation code from the previous ECM) |
|
|
Refer to INITIALIZATION [06/2017 - 08/2018]
, or refer to INITIALIZATION [08/2018 - ]
for Initialization Refer to REGISTRATION [06/2017 - ] for Registration |
| Replacement of ECM (If impossible, read the transaxle compensation code from the previous ECM) |
|
||
| Replacement of ECM | Code registration (Smart key System (for Start Function)) |
|
Refer to REGISTRATION [03/2017 - 09/2019] , or refer to REGISTRATION [09/2019 - 08/2022] |
- *1: When performing learning using the Techstream.
Refer to CALIBRATION [06/2017 - 10/2020]
- *2: When the ECM is replaced with a new one, reset memory is unnecessary.
NOTE:
- After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [06/2017 - 09/2019] , or refer to PRECAUTION [09/2019 - 03/2020] , or refer to PRECAUTION [03/2020 - ]
- If the ECM has been struck or dropped, replace it.
- Perform Vehicle Identification Number (VIN) registration when replacing the ECM.
Refer to REGISTRATION [06/2017 - ]