Installation [06/2017 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL CRANKSHAFT POSITION SENSOR
- Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.NOTE:
If reusing the crankshaft position sensor, be sure to inspect the O-ring.
- Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
NOTE:- If the crankshaft position sensor has been struck or dropped, replace it.
- Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.
- Connect the crankshaft position sensor connector.
- Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
- INSTALL CRANKSHAFT POSITION SENSOR PROTECTOR
- Install the crankshaft position sensor protector to the cylinder block sub-assembly and oil pan sub-assembly with the 3 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
- Install the crankshaft position sensor protector to the cylinder block sub-assembly and oil pan sub-assembly with the 3 bolts.
- INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH (TWC: Front Catalyst)
Refer to INSTALLATION [06/2017 - ]