LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Control System (2GR-FKS) - Service Information (Except Hybrid)) >> CAMSHAFT OIL CONTROL VALVE (for Intake Side of Bank 2) >> Removal [08/2022 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during camshaft timing gear bolt removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System Refer to INITIALIZATION [10/2020 - ]
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System Refer to INITIALIZATION [03/2017 - ]
Panoramic View Monitor System Refer to INITIALIZATION [10/2020 - ]
Replacement of ECM Vehicle Identification Number (VIN) registration MIL comes on Refer to REGISTRATION [06/2017 - ]
ECU communication ID registration (Immobiliser system) Engine start function Refer to REGISTRATION [08/2022 - ]
Gas leak from exhaust system is repaired Inspection After Repair
  • Poor idle, etc.
  • Engine start function, etc.
 Refer to INITIALIZATION [09/2019 - ]
Replacement of ECM
(If possible, read the transaxle compensation code from the previous ECM)
  1. Reset memory*1
  2. Transfer transaxle compensation code
  3. Perform road test to allow ECM to learn
  • Large shift shock
  • Deterioration of fuel efficiency
 Refer to INITIALIZATION [08/2018 - ] for Initialization
Refer to REGISTRATION [06/2017 - ] for Registration
Replacement of ECM
(If impossible, read the transaxle compensation code from the previous ECM)
  1. Reset memory*1
  2. Reset transaxle compensation code
  3. Perform road test to allow ECM to learn
For UA80E 
  1. Automatic transaxle fluid
 ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly. Refer to INITIALIZATION [08/2018 - ]
Replacement of ECM Code registration
  • Wireless door lock control system
  • Smart key system (for Entry Function)
  • Smart key system (for Start Function)
 Refer to REGISTRATION [08/2022 - ]
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)		 Rear television camera assembly optical axis (Back camera position setting) Parking assist monitor system Refer to INITIALIZATION [03/2017 - ] for Initialization
Refer to CALIBRATION [10/2020 - ] for Calibration
Replacement of front bumper assembly Front television camera view adjustment Panoramic view monitor system Refer to INITIALIZATION [10/2020 - ] for Initialization
Refer to CALIBRATION [10/2020 - ] for Calibration
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
  • Television camera controller initialization
  • Adjust steering angle
  • Rear television camera assembly optical axis (Back camera position setting)
Front wheel alignment adjustment
  • Perform "Reset Memory"
  • Perform acceleration sensor zero point calibration and system information memorization
  • VSC disabled or malfunctioning
  • DTCs are output
  • Slip indicator light illuminated
  • ABS warning light illuminated
 Refer to CALIBRATION [08/2021 - ]

*1: When the ECM is replaced with a new one, reset memory is unnecessary.

scientia non olet · About LEMON Manuals