Inspection [06/2017 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT CAMSHAFT TIMING GEAR BOLT
- Check the stroke of the plunger in the center of the camshaft timing gear bolt.
*a Plunger Standard Stroke
2.2 mm (0.0866 in.) or more
HINT:
When pressing the plunger, there may be a stepped feeling. This is not a malfunction.
If the result is not as specified, replace the camshaft timing gear bolt.
- Check the stroke of the plunger in the center of the camshaft timing gear bolt.