LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission System (UA80E) - Service Information (1 Of 3) (Except Hybrid)) >> Valve Body Assembly >> Removal [06/2017 - 08/2018] >> Procedure

Removal [06/2017 - 08/2018]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE TRANSMISSION WIRE 

    Refer to REMOVAL [06/2017 - 08/2018] 

  2. REMOVE TRANSMISSION VALVE BODY ASSEMBLY 
    1. Disengage the clamp to disconnect the transmission revolution sensor (NC) wire connector.
      GTY694199Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 9 bolts and transmission valve body assembly from the automatic transaxle case sub-assembly.
      GTY694200Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 2 transaxle case gaskets from the automatic transaxle case sub-assembly.
      GTY713641Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Transaxle Case Gasket
      *2 No. 1 Front Oil Pump Cover Gasket
      *3 No. 2 Front Oil Pump Cover Gasket
    4. Remove the transaxle case gasket from the counter drive gear sub-assembly.
    5. Remove the No. 1 front oil pump cover gasket from the front oil pump assembly.
    6. Remove the No. 2 front oil pump cover gasket from the front oil pump assembly.
scientia non olet · About LEMON Manuals