Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front bumper assembly (w/ Panoramic view monitor system) | Front television camera view adjustment | Panoramic view monitor system | Refer to INITIALIZATION [06/2017 - 10/2020]
for Initialization Refer to CALIBRATION [06/2017 - 10/2020] for Calibration |
| Front bumper assembly (w/ Intuitive Parking Assist System) |
|
|
Refer to CALIBRATION [06/2017 - 10/2020] |