Inspection [06/2017 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

Shift Paddle Switch LH (Transmission Shift Switch Assembly):

Measure the resistance according to the value(s) in the table below.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Component without harness connected (Shift Paddle Switch LH (Transmission Shift Switch Assembly))

Standard Resistance

Tester Connection	Condition	Specified Condition
1 (SDN) - 2 (ECC)	"-" (Down shift) shift paddle switch operated and held	Below 2.5 Ω
1 (SDN) - 2 (ECC)	"-" (Down shift) shift paddle switch not operated	1 MΩ or higher
1 (SDN) - 3 (ECC1)	"-" (Down shift) shift paddle switch operated and held	Below 2.5 Ω
1 (SDN) - 3 (ECC1)	"-" (Down shift) shift paddle switch not operated	1 MΩ or higher

If the result is not as specified, replace the shift paddle switch LH (transmission shift switch assembly).

Shift Paddle Switch RH (Transmission Shift Switch Assembly):

Measure the resistance according to the value(s) in the table below.

*a	Component without harness connected (Shift Paddle Switch RH (Transmission Shift Switch Assembly))

Standard Resistance

Tester Connection	Condition	Specified Condition
1 (SUP) - 2 (ECC)	"+" (Up shift) shift paddle switch operated and held	Below 2.5 Ω
1 (SUP) - 2 (ECC)	"+" (Up shift) shift paddle switch not operated	1 MΩ or higher

If the result is not as specified, replace the shift paddle switch RH (transmission shift switch assembly).