Replacement [06/2017 - 08/2018]: Procedure

Refer to REMOVAL [06/2017 - 08/2018]

Refer to PROCEDURE - Step 17

1. Using SST, remove the front drive shaft oil seal LH from the automatic transaxle case sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   • SST: 09308-00010 
   NOTE:

   Be careful not to damage the automatic transaxle case sub-assembly.

1. Using SST, remove the front drive shaft oil seal RH from the transaxle housing.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   • SST: 09308-00010 
   NOTE:

   Be careful not to damage the transaxle housing.

1. Using SST and a hammer, install a new front drive shaft oil seal RH to the transaxle housing.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Depth

   • SST: 09316-10010 
   • SST: 09950-70010 
     1. 09951-07150

   Standard Depth

   -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

   NOTE:

   • Make sure that the front drive shaft oil seal RH is installed in the correct direction.
   • Do not damage the lip of the front drive shaft oil seal RH.

1. Using SST and a hammer, install a new front drive shaft oil seal LH to the automatic transaxle case sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Depth

   • SST: 09649-17010 
   • SST: 09950-70010 
     1. 09951-07100

   Standard Depth

   -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

   NOTE:

   • Make sure that the front drive shaft oil seal LH is installed in the correct direction.
   • Do not damage the lip of the front drive shaft oil seal LH.

Refer to PROCEDURE - Step 4

Refer to INSTALLATION [06/2017 - ]