Inspection [06/2017 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT COMBINATION SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
- Inspect the NORMAL mode switch:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly))Standard Resistance
Tester Connection Condition Specified Condition 13 (B) - 16 (GND1) NORMAL mode switch being pushed and held Below 1 Ω NORMAL mode switch not pushed 10 kΩ or higher If the result is not as specified, replace the combination switch (electric parking brake switch assembly).
- Measure the resistance according to the value(s) in the table below.
- Inspect the SPORT mode switch:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly))Standard Resistance
Tester Connection Condition Specified Condition 12 (P) - 16 (GND1) SPORT mode switch being pushed and held Below 1 Ω SPORT mode switch not pushed 10 kΩ or higher If the result is not as specified, replace the combination switch (electric parking brake switch assembly).
- Measure the resistance according to the value(s) in the table below.
- Inspect the illumination:
- Apply battery voltage to the combination switch (electric parking brake switch assembly) and check that the switch illuminates.
OK
Condition Specified Condition Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 7 (ILL-)Illuminates *a Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly))If the result is not as specified, replace the combination switch (electric parking brake switch assembly).
- Apply battery voltage to the combination switch (electric parking brake switch assembly) and check that the switch illuminates.
- Inspect the NORMAL mode switch: