Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
ALL
| The monitor will run whenever the following DTCs are not stored | None |
| Solenoid current cut status | Not cut |
| Engine switch | On (IG) |
| Starter | OFF |
| Battery voltage | 10.5 V or more |
CONDITION (A)
| Battery voltage | 8 V or more and less than 12.499 V |
| Target current (0.1 sec. or more) | 0.8 A or less |
CONDITION (B)
| Battery voltage | 12.5 V or more and less than 16 V |
| Target current (0 sec. or more) | 1 A or less |