DTC P0500-31: Vehicle Speed Sensor "A" No Signal [06/2017 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Transmission / Data List / Vehicle Speed.
5. Drive the vehicle.
6. In accordance with the display on the Techstream, read the Data List.

   Powertrain > Transmission > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Vehicle Speed	Vehicle speed	Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph)	Actual vehicle speed	This is the current vehicle speed. The vehicle speed is detected using the wheel speed sensors. Vehicle speed data is delayed when it is displayed. Therefore, even if the vehicle speed listed in the freeze frame data is 0 km/h (0 mph), this does not always mean that the malfunction occurred when the vehicle was stopped.

   Powertrain > Transmission > Data List 

   Tester Display
   Vehicle Speed

   OK

   Vehicle speed displayed on the Techstream and speedometer display are equal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2017 - 08/2018]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2018 - 09/2019]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2019 - 03/2020]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [03/2020 - 10/2020]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2020 - 08/2021]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2021 - ] 

Result: 

NG 

See step  2

1. Check the circuits that send vehicle speed signals to this system in the meter system.

   Refer to Speed Signal Circuit [06/2017 - 09/2019] , or refer to Speed Signal Circuit [09/2019 - ]

2. During inspection for the meter section, if there is an instruction that indicates to go back to inspections for each system, proceed to the next step.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Disconnect the K21 combination meter assembly connector.
2. Disconnect the A21 ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   K21-6 (+S) - A21-39 (SPD)	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

1. Replace the ECM.

   Refer to REMOVAL [06/2017 - 10/2020] , or refer to REMOVAL [10/2020 - 08/2022] , or refer to REMOVAL [08/2022 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM REGISTRATION. Refer to  REGISTRATION [06/2017 - ]