Monitor Description
WARNING: This page is about a different variant/trim than selected.
The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, this DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P060A-47 | Internal Control Module Monitoring Processor Performance Watchdog/Safety MCU Failure | A CPU reset is performed after one of the following conditions is met (1 trip detection logic):
|
ECM | Comes on | DTC stored | SAE Code: P060A DTC for Mexico Models: Applies |