Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
| Monitor runs whenever the following DTCs are not stored | None |
| All of the following conditions are met | - |
| Either of the following conditions is met | 1 or 2 |
| 1. Both of the following conditions are met | (a) and (b) |
| (a) Last command to thermostat heater | Off |
| (b) Current command to thermostat heater | Off |
| 2. Both of the following conditions are met | (c) and (d) |
| (c) Last command to thermostat heater | On |
| (d) Current command to thermostat heater | On |
| Battery voltage | 8 V or higher |
| Starter | Off |
| Command to thermostat heater | On |