DTC P0110-2A: Intake Air Temperature Sensor 1 Bank 1 Signal Stuck in Range [08/2018 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Trouble Codes.
5. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTC P0110-2A and other DTCs are output	A
   DTC P0110-2A is output	B

   HINT: 

   • If any DTCs other than P0110-2A are output, troubleshoot those DTCs first.
   • Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

     Refer to INITIALIZATION [08/2018 - 09/2019] , or refer to INITIALIZATION [09/2019 - ]

Result: 

A 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2018 - 09/2019]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2019 - 10/2020]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2020 - ] 

Result: 

B 

REPLACE MASS AIR FLOW METER SUB-ASSEMBLY. Refer to  REMOVAL [06/2017 - ]