LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (Engine Control System (2GR-FKS) - Diagnostic Codes (2 Of 9) (Except Hybrid)) >> SFI System >> DTC P0088-00: Fuel Rail / System Pressure - Too High [06/2017 - 08/2018] >> Description

DTC P0088-00: Fuel Rail / System Pressure - Too High [06/2017 - 08/2018]: Description

WARNING: This page is about a different variant/trim than selected.

Refer to DTC P0087-00.

Refer to DESCRIPTION 

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P0088-00 Fuel Rail / System Pressure - Too High Although the ECM is requesting the fuel pump assembly (for high pressure side) to open the spill control valve, fuel pressure increases 3 MPa (30.6 kgf/cm2 , 435 psi) from target pressure for about 10 seconds (1 trip detection logic).
  • Fuel pump assembly (for high pressure side)
  • Fuel pressure sensor (for high pressure side)
  • ECM
Comes on DTC stored SAE Code: P0088
DTC for Mexico Models: Applies