DTC P0335-1F: Crankshaft Position Sensor "A" Circuit Intermittent; DTC P0335-2A: Crankshaft Position Sensor "A" Signal Stuck in Range; DTC P0335-31: Crankshaft Position Sensor "A" No Signal [06/2017 - 08/2018]: Description
WARNING: This page is about a different variant/trim than selected.
Refer to DTC P0335-11.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P0335-1F | Crankshaft Position Sensor "A" Circuit Intermittent | Under conditions (a), (b) and (c), no crankshaft position sensor signal to ECM for 0.05 seconds or more (1 trip detection logic): (a) Engine speed is 1000 rpm or higher. (b) Starter signal is off. (c) 3 seconds or more have elapsed since the starter signal switched from on to off. |
|
Does not come on | DTC stored | SAE Code: P0339 DTC for Mexico Models: Applies |
| P0335-2A | Crankshaft Position Sensor "A" Signal Stuck in Range | No crankshaft position sensor signal to the ECM while cranking (1 trip detection logic). |
|
Comes on | DTC stored | SAE Code: P0335 DTC for Mexico Models: Applies |
| P0335-31 | Crankshaft Position Sensor "A" No Signal | The engine stalls and the engine speed signal value decreases rapidly (1 trip detection logic). |
|
Comes on | DTC stored | SAE Code: P0335 DTC for Mexico Models: Applies |
- Reference: Inspection using an oscilloscope.