Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
CORRELATION MONITOR WITH BAROMETRIC PRESSURE
| All of the following conditions are met | - |
| Engine coolant temperature sensor malfunction (P0117, P0118) | Not detected |
| High pressure fuel pump malfunction (P1235) | Not detected |
| Fuel pressure sensor (for high pressure side) circuit malfunction | Not detected |
| Soak timer malfunction | Not detected |
| Atmospheric pressure sensor malfunction | Not detected |
| Battery voltage | 8 V or higher |
| Engine switch | Off |
| Atmospheric pressure | 76 kPa (abs) [11 psi (abs)] or higher |
STUCK MONITOR
| All of the following conditions are met | - |
| Engine coolant temperature sensor malfunction (P0117, P0118) | Not detected |
| High pressure fuel pump malfunction (P1235) | Not detected |
| Fuel pressure sensor (for high pressure side) circuit malfunction | Not detected |
| Soak timer malfunction | Not detected |
| Atmospheric pressure sensor malfunction | Not detected |
| Battery voltage | 11 V or higher |
| Fuel cut | Off |
| Injection mode | NOT PFI (Port fuel injection) |