LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Fuel System (2GR-FKS) - Service Information (Except Hybrid)) >> Fuel Sender Gauge Assembly >> Removal [10/2020 - ] >> Procedure

Removal [10/2020 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY 

    Refer to REMOVAL [10/2020 - ] 

  2. REMOVE FUEL SENDER GAUGE ASSEMBLY 
    1. Disconnect the fuel sender gauge assembly connector.
      GTY760866Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 2 clamps to disconnect the wire harness from the fuel suction plate sub-assembly.
      NOTE:

      Do not damage the wire harness.

    3. Disengage the claw to remove the fuel sender gauge assembly from the fuel suction tube with pump and gauge assembly.
      GTY754960Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Be careful not to bend the arm of the fuel sender gauge assembly.

scientia non olet · About LEMON Manuals