Removal [06/2017 - 10/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Refer to REMOVAL [06/2017 - 09/2019] , or refer to REMOVAL [09/2019 - 10/2020]

REMOVE FUEL SENDER GAUGE ASSEMBLY

Disconnect the fuel sender gauge assembly connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the 2 clamps to disconnect the wire harness from the fuel suction plate sub-assembly.
NOTE:
Do not damage the wire harness.

Disengage the claw to remove the fuel sender gauge assembly from the fuel suction tube with pump and gauge assembly.

NOTE:

Be careful not to bend the arm of the fuel sender gauge assembly.