LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Fuel System (2GR-FKS) - Service Information (Except Hybrid)) >> Fuel Sender Gauge Assembly >> Installation [06/2017 - ] >> Procedure

Installation [06/2017 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. Engage the claw to install the fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.
      NOTE:

      Be careful not to bend the arm of the fuel sender gauge assembly.

    2. Engage the 2 clamps to connect the wire harness to the fuel suction plate sub-assembly.
      NOTE:

      Do not damage the wire harness.

    3. Connect the fuel sender gauge assembly connector.
  2. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY 

    Refer to INSTALLATION [06/2017 - 09/2019] , or refer to INSTALLATION [09/2019 - ] 

scientia non olet · About LEMON Manuals