LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Fuel System (2GR-FKS) - Service Information (Except Hybrid)) >> FUEL PRESSURE SENSOR (for High Pressure) >> Removal [06/2017 - 10/2020] >> Procedure

Removal [06/2017 - 10/2020]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE FUEL PRESSURE SENSOR (FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY LH) 

    Refer to REMOVAL [06/2017 - 10/2020] 

    NOTE:
    • Do not remove the fuel pressure sensor from the fuel delivery pipe with sensor assembly LH.
    • If the fuel pressure sensor is removed, replace the fuel pressure sensor (fuel delivery pipe with sensor assembly LH) with a new one.
  2. REMOVE FUEL PIPE PLUG SUB-ASSEMBLY 
    1. Secure the fuel delivery pipe with sensor assembly LH in a vise between aluminum plates.
      NOTE:

      Do not overtighten the vise.

      GTY669090Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a 5 mm hexagon socket wrench, remove the 2 bolts, gasket and fuel pipe plug sub-assembly from the fuel delivery pipe with sensor assembly LH.
    3. w/ Dust Cap:
      1. Remove the dust cap sub-assembly from the fuel pipe plug sub-assembly.
    4. Remove the O-ring, No. 1 fuel injector back-up ring, No. 2 fuel injector back-up ring and No. 3 fuel injector back-up ring from the fuel pipe plug sub-assembly.
    5. Remove the fuel delivery pipe with sensor assembly LH from the vise.
scientia non olet · About LEMON Manuals