Inspection [06/2017 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT FUEL INJECTOR ASSEMBLY NOTE:
This inspection is for checking the fuel injector assembly for an open or short. Because the fuel injector assembly of this vehicle is a high-pressure type, fuel injection volume cannot be checked.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 1.74 to 2.04 Ω If the result is not as specified, replace the fuel injector assembly.
*a Component without harness connected
(Fuel Injector Assembly)
- Measure the resistance according to the value(s) in the table below.