DTC P2610-29: ECM/PCM Engine Off Timer Performance Signal Invalid; DTC P2610-93: ECM/PCM Engine Off Timer Performance No Operation [06/2017 - 08/2018]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REPLACE ECM
- Replace the ECM.
Refer to REMOVAL [06/2017 - 10/2020]
Result
Proceed to NEXT
Result:
NEXT
See step 2
- Replace the ECM.
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Clear the DTC.
Powertrain > Engine > Clear DTCs
- Turn the engine switch off and wait for at least 30 seconds.
Result
Proceed to NEXT
Result:
NEXT
See step 3
- CHECK WHETHER DTC OUTPUT RECURS (DTC P2610-29 OR P2610-93)
- Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
- Enter the following menus: Powertrain / Engine / Trouble Codes / Pending.
Powertrain > Engine > Trouble Codes
- If no pending DTC is output, the repair has been successfully completed.
Result
Proceed to NEXT
Result:
NEXT
END