Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
NOTE:
Inspect the fuses for circuits related to this system before performing the following procedure.
HINT:
- Stop light switch assembly conditions can be checked using the Techstream.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Data List / Stop Light SW.
- Check the Data List indication when the brake pedal is depressed and released.
Brake Pedal Operation Stop Light SW Depressed ON Released OFF
- Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.