DTC P0365-2A: Camshaft Position Sensor "B" Bank 1 Signal Stuck in Range; DTC P0365-31: Camshaft Position Sensor "B" Bank 1 No Signal; DTC P0390-31: Camshaft Position Sensor "B" Bank 2 No Signal [08/2018 - ]: Description
WARNING: This page is about a different variant/trim than selected.
Refer to DTC P0365-11.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P0365-2A | Camshaft Position Sensor "B" Bank 1 Signal Stuck in Range | No VVT sensor (for exhaust camshaft of bank 1) signal to ECM while engine cranking (1 trip detection logic). |
|
Comes on | DTC stored | SAE Code: P0365 |
| P0365-31 | Camshaft Position Sensor "B" Bank 1 No Signal | No VVT sensor (for exhaust camshaft of bank 1) signal for 5 seconds at an engine speed of 600 rpm or higher (1 trip detection logic). |
|
Comes on | DTC stored | SAE Code: P0365 |
| P0390-31 | Camshaft Position Sensor "B" Bank 2 No Signal | No VVT sensor (for exhaust camshaft of bank 2) signal for 5 seconds at an engine speed of 600 rpm or higher (1 trip detection logic). |
|
Comes on | DTC stored | SAE Code: P0390 |
Reference: Inspection using an oscilloscope.