DTC P0013-13: Camshaft Position "B" - Actuator Bank 1 Circuit Open; DTC P0023-13: Camshaft Position "B" - Actuator Bank 2 Circuit Open [08/2018 - 09/2019]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTC after recording the Freeze Frame Data and DTC.

   Powertrain > Engine > Clear DTCs 

5. Turn the engine switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Connect the Techstream to the DLC3.
2. Start the engine.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Trouble Codes.
5. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTC P0013-13 or P0023-13 is output	A
   DTCs are not output	B

Result: 

B 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [06/2017 - ] 

Result: 

A 

See step  3

1. Inspect the cam timing oil control solenoid assembly (for exhaust camshaft).

   Refer to INSPECTION [06/2017 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (FOR EXHAUST CAMSHAFT). Refer to  REMOVAL [06/2017 - ] 

Result: 

OK 

See step  4

1. Disconnect the cam timing oil control solenoid assembly (for exhaust camshaft) connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C25-1 (+) - C96-4 (OE1+)	Always	Below 1 Ω
   C25-2 (-) - C96-5 (OE1-)	Always	Below 1 Ω
   C106-1 (+) - C96-2 (OE2+)	Always	Below 1 Ω
   C106-2 (-) - C96-3 (OE2-)	Always	Below 1 Ω
   C25-1 (+) or C96-4 (OE1+) - Body ground and other terminals	Always	10 kΩ or higher
   C25-2 (-) or C96-5 (OE1-) - Body ground and other terminals	Always	10 kΩ or higher
   C106-1 (+) or C96-2 (OE2+) - Body ground and other terminals	Always	10 kΩ or higher
   C106-2 (-) or C96-3 (OE2-) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [06/2017 - 10/2020] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR