Parts Location [06/2017 - ]: Illustration
WARNING: This page is about a different variant/trim than selected.
| *1 | FRONT ENGINE MOUNTING INSULATOR | *2 | REAR ENGINE MOUNTING INSULATOR |
| *3 | CANISTER | *4 | FUEL PUMP (for Low Pressure Side) |
| *5 | MASS AIR FLOW METER SUB-ASSEMBLY | *6 | PARK / NEUTRAL POSITION SWITCH ASSEMBLY |
| *7 | VACUUM SWITCHING VALVE (for Active Control Engine Mount System) | *8 | ENGINE ROOM RELAY BLOCK AND JUNCTION BLOCK ASSEMBLY |
| *9 | FUEL PUMP CONTROL ECU | *10 | CANISTER PUMP MODULE |
| *11 | ECM | - | - |
| *1 | AIR FUEL RATIO SENSOR (Bank 2 Sensor 1) | *2 | CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Camshaft of Bank 1) |
| *3 | CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exhaust Camshaft of Bank 1) | *4 | CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Camshaft of Bank 2) |
| *5 | CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exhaust Camshaft of Bank 2) | *6 | FUEL INJECTOR ASSEMBLY (for Port Injection) |
| *7 | FUEL INJECTOR ASSEMBLY (for Direct Injection) | *8 | FUEL PRESSURE SENSOR (for Low Pressure Side) |
| *9 | WATER INLET WITH THERMOSTAT SUB-ASSEMBLY | - | - |
| *1 | AIR FUEL RATIO SENSOR (Bank 1 Sensor 1) | *2 | ENGINE COOLANT TEMPERATURE SENSOR |
| *3 | FUEL PRESSURE SENSOR (for High Pressure Side) | *4 | FUEL PUMP ASSEMBLY (for High Pressure Side) |
| *5 | VVT SENSOR (for Intake Camshaft of Bank 1) | *6 | VVT SENSOR (for Exhaust Camshaft of Bank 1) |
| *7 | VVT SENSOR (for Intake Camshaft of Bank 2) | *8 | VVT SENSOR (for Exhaust Camshaft of Bank 2) |
| *9 | IGNITION COIL ASSEMBLY | *10 | CRANKSHAFT POSITION SENSOR |
| *1 | HEATED OXYGEN SENSOR (Bank 2 Sensor 2) | *2 | HEATED OXYGEN SENSOR (Bank 1 Sensor 2) |
| *3 | KNOCK CONTROL SENSOR (Bank 1) | *4 | KNOCK CONTROL SENSOR (Bank 2) |
| *5 | PURGE VSV | *6 | THROTTLE BODY WITH MOTOR ASSEMBLY |
| *7 | NO. 1 VACUUM SWITCHING VALVE (for Intake Air Control Valve Sub-assembly) | - | - |