DTC P161A-87: Lost Communication with Alternator Missing Message [06/2017 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK CHARGING SYSTEM
- Check the charging system.
Refer to ON-VEHICLE INSPECTION [06/2017 - ]
Result
Result OK NG
Result:
NG
REPAIR OR REPLACE CHARGING SYSTEM
Result:
OK
See step 2
- Check the charging system.
- CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)
- Disconnect the C96 ECM connector.
- Disconnect the C60 generator assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition C96-135 (LIN) - C60-2 (LIN) Always Below 1 Ω C96-135 (LIN) or C60-2 (LIN) - body ground Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE GENERATOR ASSEMBLY. Refer to REMOVAL [06/2017 - 10/2020] , or refer to REMOVAL [10/2020 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR