LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Lubrication System (2GR-FKS) - Service Information (Except Hybrid)) >> Oil Pump >> Removal [10/2020 - 08/2022] >> Procedure

Removal [10/2020 - 08/2022]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE OIL PAN SUB-ASSEMBLY 

    Refer to REMOVAL [10/2020 - 08/2022]

  2. REMOVE TIMING CHAIN CASE OIL SEAL 

    Refer to PROCEDURE - Step 4

  3. REMOVE TIMING CHAIN COVER ASSEMBLY 
    1. w/ Stud Bolt:
      GTY661147Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Nut
      1. Remove the 23 bolts and 2 nuts shown in the illustration.
    2. w/o Stud Bolt:
      GTY948257Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Remove the 25 bolts shown in the illustration.
    3. Remove the timing chain cover assembly by prying between the timing chain cover assembly and cylinder head sub-assembly or cylinder block sub-assembly with a screwdriver with its tip wrapped with protective tape.
      GTY619684Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      NOTE:

      Be careful not to damage the contact surfaces of the cylinder head sub-assembly, cylinder block sub-assembly and timing chain cover assembly.

    4. Remove the oil pump gasket from the cylinder block sub-assembly.
      GTY658300Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals