LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2018 >> Camry LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Lubrication System (2GR-FKS) - Service Information (Except Hybrid)) >> Oil Pressure Switch >> Inspection [06/2017 - ] >> Procedure

Inspection [06/2017 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Disengage the clamp to disconnect the wire harness protector.
      GTY765569Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Wire Harness Protector
    2. Disconnect the engine oil pressure switch assembly connector.
    3. Start the engine.
    4. Measure the resistance according to the value(s) in the table below.
      GTY147711Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - Switch body Idling 10 kΩ or higher
      Engine stopped Below 1 Ω

      If the result is not as specified, replace the engine oil pressure switch assembly.

    5. Connect the engine oil pressure switch assembly connector.
    6. Connect the wire harness protector.
scientia non olet · About LEMON Manuals